User's Manual

USING SETUP MODE
5-48 User's Manual
Table 5.7 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG
Items
Options Description
<FCNTARE> Area-over detection control of front
continuous forms.
ENABLE1 Detects the left and right edges of
paper when loading the paper.
ENABLE2 Detects the left and right edges of
paper at 13mm and 43mm from top
of the paper. This setting is
effective if the left and right edges
are not detected by <ENABLE1>
for preprint papers, etc.
DISABLE
Does not detect the edges. Select
this option when you are using
colored or preprinted paper.
<RCNTARE>
Area-over detection control of rear
continuous forms.
ENABLE1
Detects the left and right edges of
paper when loading the paper.
ENABLE2 Detects the left and right edges of
paper at 13mm and 43mm from top
of the paper. This setting is
effective if the left and right edges
are not detected by <ENABLE1>
for preprint papers, etc.
DISABLE
Does not detect the edges. Select
this option when you are using
colored or preprinted paper.
<CUT-ARE>
Area-over detection control of cut
sheets.
ENABLE1
Detects the left and right edges of
paper when loading the paper.
ENABLE2
Detects the left and right edges of
paper at 13mm and 43mm from top
of the paper. This setting is
effective if the left and right edges
are not detected by <ENABLE1>
for preprint papers, etc.
DISABLE
Does not detect the edges. Select
this option when you are using
colored or preprinted paper.
Table 5.7 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.