User's Manual

USING SETUP MODE
User's Manual 5-59
This section describes how to exit setup mode and save any changes you
made:
To exit setup mode immediately, select the SAVE & END (for LED
type) SAVE&EXIT (for LCD type) function.
Any settings changed while in setup mode are saved as the new power-
on defaults for the printer. The new defaults remain active until you
change them again.
NOTE (LED only)
The only way to exit setup mode without saving your changes is to
turn off the printer. When you turn the printer back on, the previous
default settings are used.
Procedure (for LED type)
To exit setup mode and save your changes using SAVE/END, proceed as
follows:
1. Print the <<FUNCTION>> menu.
The <<FUNCTION>> menu should be the last printed line on
the page. If the menu is not printed, press the ONLINE button to
print the menu. The <<FUNCTION>> menu is shown below:
<< FUNCTION >>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG GAP-ADJ DEFAULT LIST SELF-
T
ST
HEX-DUMP V-ALMNT INITIAL
2. Select the SAVE/END function.
Make sure that the cursor on the left edge of the aluminum print
guide is positioned under SAVE & END. Press the button or
the button to select SAVE & END. The printer exits setup
mode and returns online (the ONLINE indicator lights green).
Any changes you made while in setup mode are saved.
Procedure (for LCD type)
To exit setup mode and save or cancel your changes using SAVE/EXIT
function, proceed as follows:
1. Push SAVE/EXIT button.
Push SAVE/EXIT button, then “ :SAVE :CANCEL” is
displayed on LCD PANEL
2. Push or button.
Push to save changing.
Push to cancel changing.
EXITING AND
SAVING