User's Manual

INSTALLING OPTIONS
User's Manual 8-3
5. Connect LAN cable
After tightening LAN card, connect LAN cable first, then the
power plug.
Please refer to the manual attached to LAN card about LAN
card setting.
This chapter describes what to do after installing cut sheet feeder.
WARNING (Electric shock)
Before mounting or removing the cut sheet feeder, turn
off the power switches of the personal computer and
the printer and remove the power plug from the outlet.
Otherwise, you may receive electric shock.
A cut sheet feeder (SF940) allows you to automatically feed single sheets.
It can be mounted on the front or the rear of the printer.
When attaching the cut sheet feeder to the rear of the printer, replacing
the stacker with large stacker is necessary (See “INSTALLING THE
LARGE STACKER” on page 8-9).
For both front and rear, the cut sheet feeder can handle a max. of 5-ply
multipart media.
When installing the front and rear cut sheet feeders, the printer assigns
the first bin to the front feeder. You can change the assignment using set
up mode.
Installing on the front side of the printer
1. Turn off the printer power.
Confirm that the printer power is turned to the  side.
2. Removing the tractor unit
INSTALLING THE
CUT SHEET
FEEDER
LAN cable