User's Manual

QUICK REFERENCE
QR-2 User's Manual
Printer Operations (Normal Mode)
: Operation can be performed when the printer is in this state.
— : Operation cannot be performed when the printer is in this state.
N/A: Does not apply.
Operation Online Offline Required Response
Enter normal mode N/A N/A Turn printer on. (Press I on the power switch.)
If STANDBY lamp lights, Press any buttons.
Place printer offlin
e
(Stop printing)

—
Press ONLINE.
So that ONLINE lamp is off.
Place printer onlin
e
(Start printing)
—

Press ONLINE.
So that ONLINE lamp lights.
Load paper
 
Press LOAD.
Line feed (forward)
 
Press LF/FF within three seconds.
Unload paper to park position
(both front and rear-fed
continuous forms)
 
Press LOAD.
Form feed (forward)
 
Press and hold LF/FF until the operation starts.
Eject single sheets
 
Press and hold LF/FF until the operation starts.
Tear off forms
(continuous forms only)
 
Press TEAR OFF. Tear off forms, then press
any button to retract forms.
Micro feed (backward)
 
Press MICRO .
Micro feed (forward)
 
Press MICRO .
Select a direction from which cut
sheet is ejected.

— Press FRONT DIR.
When FRONT DIR lamp lights, cut sheet is
ejected to the front side.
When FRONT DIR lamp is off, cut sheet is
ejected to the rear side.
Select a print mode
 
Press PRINT MODE.
Set/reset high impact mode
 
Press HI IMPACT.
Select a paper input source
 
Press PAPER PATH.