User's Manual

PAPER HANDLING
3-4 User's Manual
Table 3.1 Buttons Used for Paper Handling (Cont.)
Button/Dial Purpose Action
(LED)
FRONT
DIR/AUTO
GAP
(LCD)
FRONT
DIR/GAP
ADJUST
Select cut
sheet ejection
(LED)
Press FRONT DIR/AUTO GAP at Offline to select
a direction of ejecting cut sheet.
(LCD)
Press FRONT DIR/ GAP ADJUST at Offline to
select a direction of ejecting cut sheet.
Front ejection – FRONT indicator lights. It blinks
when paper is ejected to the paper table prompting
the user to remove the paper.
 Rear ejection – FRONT indicator does not
light.
When you save your setting in the setup mode, it
becomes the new default. The default setting is
invoked whenever you turn on the printer.
MICRO Micro Feed Press MICRO/ MICRO to feed paper by 1/180
inch in the direction of the arrow.
MICRO
(LED)
AUTO GAP
Select paper
thickness
control mode
Select paper thickness control mode.
AUTO GAP — AUTO GAP indicator lights.
Manual Gap — AUTO GAP indicator doesn't
lights.
The Manual Gap dial is enabled.
(LED)
MANUAL
GAP DIAL
Select paper
Thickness at
MANUAL
MODE
Select the paper thickness at MANUAL MODE.
Auto Gap is usually used. Auto Gap is used for
printing on paper of different thicknesses.
(LCD)
GAP
ADJUST
Select paper
Thickness
Select the paper thickness as follows.
AUTO,GAP-1,･･･････,GAP-9,GAP-A,･･,GAP-D