Installation Instructions
Table Of Contents
- User Guide
- Contents
- Preface
- 1 About this Guide
- 2 Overview
- 3 RU Hardware Feature
- 3.1 System Configuration
- 3.2 RU Specifications
- 3.3 Environment Specification
- 3.4 RU Downlink/Uplink Default Parameters
- 3.5 Antenna Configuration
- 3.6 Carrier Configuration
- 3.7 Block Diagram
- 3.8 External Interface
- 3.9 TX Control Function
- 3.10 Performance Requirement
- 3.11 Mechanical Design and Other Options
- 4 Ordering Information
- 5 Installation
- 6 Operations
- 7 Maintenance and Trouble Clearing
- 8 Removal
- A References
- B ZTP Overview
- C Optical Connector Cleaning
- D Glossary
- Index
Step 5
Add prot ective covers to the opt ical fibers.
Step 6
Insert prot ective covers t o both mat ing connectors.
✓ This task is complete.
8.1.5
Remove SFP Module
This procedure describes how to remove the SFP module from the RU.
Prerequisite:
■ RU pow ered off
Danger: Use properly insulated tools and perform all safety precautions in accordance wit h local safety
practices when working on or around power terminals, power cables, and pow er connectors. Cont acting
power terminals, uninsulat ed conductors, cable wiring, or any connector that could be part of a live
electrical circuit can result in deat h or serious personal injury.
Step 1
Locate the SFP in the eCPRI port on the RU.
Step 2
Lift the lever on the SFP.
Step 3
Pull the SFP out of the eCPRI port .
Step 4
Apply a protective cover to the eCPRI port .
✓ This task is complete.
Removal
Cable Removal
115
Release 1.0 · Issue 1, M arch 2021
Fujitsu and Fujitsu Customer Use Only