Installation Instructions
Table Of Contents
- User Guide
- Contents
- Preface
- 1 About this Guide
- 2 Overview
- 3 RU Hardware Feature
- 3.1 System Configuration
- 3.2 RU Specifications
- 3.3 Environment Specification
- 3.4 RU Downlink/Uplink Default Parameters
- 3.5 Antenna Configuration
- 3.6 Carrier Configuration
- 3.7 Block Diagram
- 3.8 External Interface
- 3.9 TX Control Function
- 3.10 Performance Requirement
- 3.11 Mechanical Design and Other Options
- 4 Ordering Information
- 5 Installation
- 6 Operations
- 7 Maintenance and Trouble Clearing
- 8 Removal
- A References
- B ZTP Overview
- C Optical Connector Cleaning
- D Glossary
- Index
Lag Bolt
Lag Bolt
Bolt (M 10x30)
Bolt (M 10x40)
Split Washer
Insulating Bushing
Insulating Bushing
Flat Washer
Split Washer
Flat Washer
FNC001580_Rev_02
Figure 29
Attaching Radio to Wall M ount Plate
Step 5
Secure the RU in place using M 10 bolt s.
a) Loosely screw two M 10 x 30 bolt s int o the holes on the top of the RU with flat and split washers used for
spacing.
b) Loosely screw two M 10 x 40 bolt s int o the holes on the lower front of the RU wit h an insulat ing stepped
bushing and flat and split washers used for spacing.
c) Torque all four M 10 bolt s to 27 Nm to secure the RU in place.
Installation
RU Installation
96
Release 1.0 ยท Issue 1, M arch 2021
Fujitsu and Fujitsu Customer Use Only