Installation Instructions
Table Of Contents
- User Guide
- Contents
- Preface
- 1 About this Guide
- 2 Overview
- 3 RU Hardware Feature
- 3.1 System Configuration
- 3.2 RU Specifications
- 3.3 Environment Specifications
- 3.4 RU Downlink/Uplink Default Parameters
- 3.5 Antenna Configuration
- 3.6 Carrier Configuration
- 3.7 Block Diagram
- 3.8 External Interface
- 3.9 TX Control Function
- 3.10 Performance Requirement
- 3.11 Mechanical Design and Other Options
- 4 Ordering Information
- 5 Installation
- 6 Operations
- 7 Maintenance and Trouble Clearing
- 8 Removal
- A References
- B ZTP Overview
- C Optical Connector Cleaning
- D Glossary
- Index
8.1.3
Remove AISG Cable
This procedure describes how to remove the AISG RET cable from the RU.
Prerequisite:
■ RU pow ered off
Danger: Use properly insulat ed tools and perform all safety precautions in accordance wit h local safety
practices when working on or around power terminals, power cables, and pow er connectors. Cont acting
power terminals, uninsulat ed conductors, cable wiring, or any connector that could be part of a live
electrical circuit can result in deat h or serious personal injury.
Step 1
On the RU, loosen the cable's out er connector shell. Repeat for the antenna end of the cable.
Note: If replacing the RU, the antenna side of the cable does not have to be removed.
Step 2
Remove the AISG cable from the AISG or the RET port on the RU.
Step 3
Remove the AISG cable from the antenna side.
✓ This task is complete.
8.1.4
Remove Optical Cable
This procedure describes how to remove optical cables from the RU.
Prerequisite:
■ RU pow ered off
Danger: Use properly insulat ed tools and perform all safety precautions in accordance wit h local safety
practices when working on or around power terminals, power cables, and pow er connectors. Cont acting
power terminals, uninsulat ed conductors, cable wiring, or any connector that could be part of a live
electrical circuit can result in deat h or serious personal injury.
Step 1
Separat e the two prot ective covers.
Step 2
Turn the optic sub-assembly enclosure count er-clockwise and gently pull the connector from the SFP port .
Removal
Cable Removal
115
Release 1.0 · Issue 1, M arch 2021
Fujitsu and Fujitsu Customer Use Only