Installation Instructions
Table Of Contents
- User Guide
- Contents
- Preface
- 1 About this Guide
- 2 Overview
- 3 RU Hardware Feature
- 3.1 System Configuration
- 3.2 RU Specifications
- 3.3 Environment Specifications
- 3.4 RU Downlink/Uplink Default Parameters
- 3.5 Antenna Configuration
- 3.6 Carrier Configuration
- 3.7 Block Diagram
- 3.8 External Interface
- 3.9 TX Control Function
- 3.10 Performance Requirement
- 3.11 Mechanical Design and Other Options
- 4 Ordering Information
- 5 Installation
- 6 Operations
- 7 Maintenance and Trouble Clearing
- 8 Removal
- A References
- B ZTP Overview
- C Optical Connector Cleaning
- D Glossary
- Index
FNC001585_Rev_01
Figure 33
Remove RU from Pole M ount
Step 5
Remove the jam nuts from each of the four 10-inch 3/ 8 bolt s holding the small and large crossmembers
toget her.
Step 6
Disconnect the small crossmembers from the large crossmembers by removing the 10-inch 3/ 8 bolts.
Removal
Detach RU From Pole
119
Release 1.0 ยท Issue 1, M arch 2021
Fujitsu and Fujitsu Customer Use Only