Installation Instructions
Table Of Contents
- User Guide
- Contents
- Preface
- 1 About this Guide
- 2 Overview
- 3 RU Hardware Feature
- 3.1 System Configuration
- 3.2 RU Specifications
- 3.3 Environment Specifications
- 3.4 RU Downlink/Uplink Default Parameters
- 3.5 Antenna Configuration
- 3.6 Carrier Configuration
- 3.7 Block Diagram
- 3.8 External Interface
- 3.9 TX Control Function
- 3.10 Performance Requirement
- 3.11 Mechanical Design and Other Options
- 4 Ordering Information
- 5 Installation
- 6 Operations
- 7 Maintenance and Trouble Clearing
- 8 Removal
- A References
- B ZTP Overview
- C Optical Connector Cleaning
- D Glossary
- Index
Step 6
Aft er cleaning, prompt ly inst all in the connector or cap and store it.
Important: Install or st ore the connector within 15 minut es of cleaning to prevent unnecessary dirt
from ent ering the connector.
Caution: Do not touch the end surfaces.
✓ This task is complete.
Additional Instructions:
■ Clean again if the connector end surface is touched after the cleaning.
■ Do not use the same part of the cleaner more than once.
■ Do not wipe the boot s of the connector for the open circuit prevention.
■ Do not touch the ferrule part of the connector to the polyethylene cleaner guide to prevent scars.
■ Do not rotat e the connector with the ferrule held to the cleaner cleaning side.
■ Do use a cleaner except to clean the ferrule.
Optical Connector Cleaning
LC Connector End Surface Cleaning
136
Release 1.0 · Issue 1, M arch 2021
Fujitsu and Fujitsu Customer Use Only