Monitor Operating Manual SCENICVIEW P17-2 / P19-2 / P20-2 English
SCENICVIEW P17-2 / P19-2 / P20-2 i Operation of the monitor The monitor offers the following possibilities that enable it to be optimally adjusted for the respective user and the respective situation. Adjusting height, rake and rotation The monitor height can be adjusted within a range of approx. 2.5 inch/70 mm. ► Grasp the monitor with both hands on the right and left edge of the casing and move it upward or downward.
SCENICVIEW P17-2 / P19-2 / P20-2 Adjusting portrait format The monitor can be turned from the "wide format" (landscape mode) into the "high format" position (portrait mode). Grasp the monitor with both hands on the right and left edge of the casing, move it into the highest position and turn it clockwise until it is in the portrait position. Ê i Ê You must use corresponding software (pivot software) so that the screen display is also shown in the portrait mode.
SCENICVIEW P17-2 / P19-2 / P20-2 Changing the monitor settings When putting the monitor into operation for the first time, the screen display should be optimally adapted to the screen controller used and adjusted in accordance with your needs.
SCENICVIEW P17-2 / P19-2 / P20-2 Locking the OSD menu The OSD menu can be locked to prevent accidental or unauthorised changes to the monitor settings. ► Press and hold the SELECT/MENU button for a few seconds while you switch on the monitor with the ON/OFF switch. A message is displayed that the action has been performed. Please proceed in the same manner to release the locked OSD menu again.
SCENICVIEW P17-2 / P19-2 / P20-2 The corresponding setting window (here: Image Adjust) is displayed (on the right-hand side). The first function (H-Position) is highlighted. ► If necessary, press the 6 or 5 button to mark another function. ► Press the SELECT/MENU button to select the highlighted function. ► Press the 6 or 5 button to adjust the value for the selected function. ► Press the EXIT/AUTO button to exit the function.
SCENICVIEW P17-2 / P19-2 / P20-2 Adjusting size and position Calling the Image adjust setting window H-Position Adjusting the horizontal position With this function you move the picture to the left or to the right. V-Position Adjusting the vertical position With this function you move the picture up or down. Clock Setting synchronisation With this function you adjust the picture width to eliminate vertical picture disturbances.
SCENICVIEW P17-2 / P19-2 / P20-2 Setting display of the OSD menu Calling the OSD Setup setting window Language Setting language for the OSD menu With this function you choose between English (default setting), French, German, Italian and Spanish as the language for the OSD menu.
SCENICVIEW P17-2 / P19-2 / P20-2 Displaying information Calling the Information setting window With this function the model designation, serial number, resolution, H/V frequency, input signal and polarity of the synchronisation signal are displayed. Notes on ergonomic colour adjustment If you select colours for the display in your application programmes, take note of the information below.
SCENICVIEW P17-2 / P19-2 / P20-2 Troubleshooting Should an error occur, first check the following points. If the distortion is still not eliminated, the monitor should, if possible, be checked on another computer. If you are unable to solve the problem, please inform our help desk.
SCENICVIEW P17-2 / P19-2 / P20-2 Having this problem? Picture is wrongly adjusted Picture disturbances (vertical lines) Check the following points: ► Press the SELECT/MENU button to activate the function Factory Recall. The Auto Processing message is displayed. ► Press the EXIT/AUTO button to perform the autoadjustment of the screen. Picture disturbances (horizontal lines, picture noise) ► The screen becomes darker The background lighting has a limited lifetime.
