Operation Manual

Working with the n otebook
Removing and installing the battery
Only use batteries approved by Fujitsu Siemens Computers for your notebook.
Never use force when inserting or removing a batt ery.
Make sure that no foreign bodies get into the battery connect ions.
Remov ing the bat tery
► Switch the notebook off and pull
the power plug out of the mains socket.
Battery
► Close the LCD screen so that it locks into place.
► Disconnect all cables connected t
o the notebook.
► Turn your noteb ook over and place it on a stable, sturdy, flat surface. If necessary, lay an
anti-slip cloth on this surface to prevent the notebook from being scrat ched .
1
2
3
► Push the battery lock in direction
of the arrow (1).
► Slide the battery release (2) in the direction
of the arrow and hold it in place.
► Remove the battery from the batte
ry
compartment (3).
Inserting the battery
2
1
► Push the battery into the batter y
compartment until it engages (1).
Battery
► Push the battery lock in directi
on
of the arrow (2).
Using the power-management features
EnergyEnergyBattery
The no tebook uses less e nergy
when the available power management functions are used. You
will then be able to work longe
r when using the ba ttery before having to rech arge it.
Energy efficiency is increa
sed and the environmental impact is reduced. If you
make best use of the power op
tions, you can achieve considerable savings
and protect the environme
nt at the same time.
When you close the lid, the n
otebook automatically enters an energy-saving mode.
Under Windows, H ibernate i
s activated by default.
We recommend you make the fo
llowing settings:
These settings are gained f
rom practical exp erience, and therefore may deviate from the
standard settings in the s
oftware pre -installation and Windows.
10600790720, edition 1 23