Operation Manual

Removing and installing components
during servicing
Please observe the safety information in the "Important notes", Pag e 4 chapter.
The notebook must b e switched off when installing/removing the memory
modules, it must not be in Suspend mode.
Only use memory upgrades which are approved fo r your notebook. 512 MByte
and 1 GByte module DDR2 -533 SO DIMM (PC2-4200).
Never use force when installing or removing memo ry modules.
Make sure that foreign objects do not fall into the memory expansion compartment.
The memory modules are located in
a larger service compartment. You must open the
service compa rtment to remove o
r install a memory mo dule. Once you have removed the
cover, the various components a
re exposed. These components should only be removed and
replaced by authorised specia
lists. B e sure to observe the following:
Individual components (e.g. t
he processor h eat sink) can become very hot
during operation. Therefor
e, we recommend that you wait one hour after
switching off the notebook
before r emoving or installing the me mory modules.
Otherwise, there is a risk o
f suffering burn s!
As some components with ESD
s are exposed, please observe the "
Notes on
installing and removing bo
ards and components", Page 41 chapter.
► Switch your notebook off.
► Close the LCD screen so that it locks into place.
► Unplug the mains p lug of the m ains adapter from the mains socket.
► Disconnect all cables connected to the notebook.
► Turn your notebook over and place it on a stable, flat and clean surface. If n ece ssary, lay
an anti-slip cloth o n this surface to prevent the notebook from being scratched .
► Remov e the battery (see "
Removing t he battery", Page 23).
Removing cover
1
1
2
► Remove the screws (1).
► Lift the cover off the notebook i n the
direction of the arrow (2).
44 10600790720, edition 1