Operation Manual

Removing and installing comp onents
during servicing
Removing and installing the har
ddisk
Removing the hard disk
► Switch the notebook off and pull the power p lug out of the mains socket.
► Close the LCD screen so that it locks into place.
► Disconnect all cables connected to the notebook.
► Turn your notebook over and place it on a stable, flat and clean surface. If necessary, lay
a non-slip cloth on this surface to prevent the notebook from being scratched.
► Remove the batter y (see "
Removing the battery", Page 24).
Harddisk
3
2
1
1
► Remo ve the screws (1).
► Lift the cover off the notebook in the
direction of the arrow (2).
► Pull the hard disk out of the hard
disk compartment in a straight line
(3) along the guide rail.
► Remove th e 2 screws from the frame of the hard disk.
► Pull the hard disk out of the frame.
Installing the hard disk
When installing the hard disk, ensure that the contacts in the hard disk
compartment do no t ben d or become damaged.
Harddisk
► Slide the hard disk into th
e frame.
► Secure the hard disk to the fram e using the 2 screws.
3
3
1
2
► Insert the hard disk into t
he hard disk
compartment (1) in a stra
ight line.
► Push the hard disk into the hard disk
compartment in a straight line until the
contacts catch. Do not use excessive
force when inserting the hard disk.
► Attach the cover in the d
irection
of the arrow (2).
► Secure the cover with the screws (3).
► Install the battery again (see "
Insertin g the battery", Page 24).
► Turn the notebook the right way up and place it on a flat surface.
► Reconnect the cables that you disconnected previously.
10600900868, edition 1 45