Operation Manual

Chapter 7 Replacing the Consumables
Appendix
Glossary
Introduction
Index
Contents
TOP
122
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Scanner
Overview
Replacing the
Consumables
5 Attach a new brake roller on the shaft.
Insert the protrusion on the shaft into the slot.
6 Attach the shaft.
1 Insert the left end of the shaft into the hole in accordance with the
hole shape, and then attach the right side of the shaft.
2 Close the cover.
7 Close the ADF.
For details, refer to "1.4 Opening/Closing the ADF" (page 27).
8 Reset the brake roller counter.
Reset the counter by performing one of the following actions:
z Reset the counter in [4: Consumable counters] on the [Settings
Menu] screen of the operator panel.
For details, refer to "4.2 Settings Menu" (page 66).
z Reset the counter in the Software Operation Panel.
For details, refer to "Resetting the sheet counters" (page 179).
Slot
Protrusion
Shaft
Brake roller
2
1
Shaft
Brake roller
ATTENTION
Confirm that the brake roller is installed properly. Otherwise, it may
cause feeding errors such as paper jams.
Be careful not to have your fingers caught
when closing the ADF.