Operation Manual

Appendix
Chapter 1 Scanner Overview
Glossary
Introduction
Index
Contents
TOP
36
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Power saving mode keeps the power consumption low when
the scanner has not been used for a certain period of time.
If the scanner is left powered on for 15 minutes without being
used, it automatically enters power saving mode.
When the scanner enters power saving mode, the LCD on the
operator panel switches off. The [Power] button remains lit in
green.
To resume from power saving mode, perform one of the
following:
z Load a document in the ADF paper chute (feeder)
z Press any button on the operator panel
Note that pressing the [Power] button for more than 2 seconds will
turn the power off.
z Perform scanning from an application
The scanner is turned off automatically if it is left on for a
certain period of time without being used, reducing the power
consumption until the next scan.
To prevent the scanner from being turned off automatically,
clear the [Power off after a certain period of time] check box in
[Device Setting] on the Software Operation Panel. For details,
refer to "Waiting Time to Enter Power Saving Mode [Power
saving]" (page 202).
To turn the power back on after turning the power off
automatically, press the [Power] button on the operator panel.
For details, refer to "1.3 Turning the Power ON/OFF" (page
25).
.
1.8 Power Saving Mode
ATTENTION
z The scanner may not enter power saving mode if there was a
document remaining on the paper path. In that case, remove the
document.
For details, refer to "8.1 Paper Jam" (page 128).
z For some applications, the scanner may not be turned off even if the
[Power off after a certain period of time] check box is selected.
z If the scanner is automatically turned off while you are using the
image scanning application, exit the application before turning the
power on.
HINT
By using one of the following, the waiting time for entering power saving
mode can be changed.
z Use the Operation Panel ([17: Power saving] in the [Settings Menu]
screen).
For details, refer to "4.2 Settings Menu" (page 66)
z Use the Software Operation Panel.
For details, refer to "Waiting Time to Enter Power Saving Mode
[Power saving]" (page 202).