Operation Manual

Chapter 5 Various Ways to Scan
Appendix
Glossary
Introduction
Index
Contents
TOP
87
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Various Ways to
Scan
Configuring the
Scan Settings
How to Use the
Operator Panel
Documents with Different Widths
1 Align the top of the documents.
2 Place the documents at the center of the ADF paper chute
(feeder), and adjust the side guides to the widest
document in the batch.
For details, refer to "Chapter 2 How to Load Documents" (page 41).
5.2 Scanning Documents of Different Types and Sizes
ATTENTION
When you scan a mixed batch with different widths, some of the smaller
documents may be skewed or not fed into the ADF. In that case,
separate the documents by their widths, and scan them in different
batches.
HINT
For more details about scanning a mixed batch of documents, refer to
"Conditions for Mixed Batch Scanning" (page 51).
ATTENTION
Make sure that all documents are placed underneath the pick
roller. Otherwise, some documents may be skewed or not fed into
the ADF.
Pick roller's width
Good
Pick roller's width
Bad