Operation Manual

Appendix
Chapter 8 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
136
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Troubleshooting
■Option error (when imprinter is installed)
Error codes beginning with the letter "A" are displayed.
■Sensor error
Error codes beginning with the letter "L" are displayed.
Error
code
Error messages Resolution
A0:B2 Imprinter error (RAM)
If the problem persists
after turning the power
back on, please inform
your service provider of
the above error code.
1 Confirm that the EXT cable of
the imprinter is connected
properly to the EXT connector
on the back of the scanner.
For details about the EXT cable,
refer to "Back" (page 18).
For details about how to connect
the EXT cable, refer to the
fi-718PR Imprinter Operator's
Guide.
2 Confirm that the print cartridge
is installed correctly.
For details, refer to the fi-718PR
Imprinter Operator's Guide.
3 Turn the scanner off then back
on.
If the problem persists, write
down the displayed error code
and contact your FUJITSU
scanner dealer or an authorized
FUJITSU scanner service
provider.
A1:B3 Imprinter error
(communication timeout)
If the problem persists
after turning the power
back on, please inform
your service provider of
the above error code.
A2:B5 Imprinter error (print
head)
If the problem persists
after turning the power
back on, please inform
your service provider of
the above error code.
A3:B6 Imprinter error (EEPROM)
If the problem persists
after turning the power
back on, please inform
your service provider of
the above error code.
A4:B8 Imprinter error (ROM)
If the problem persists
after turning the power
back on, please inform
your service provider of
the above error code.
Error
code
Error messages Resolution
L 0 :11
L2:13
Sensor error
If the problem persists
after turning the power
back on, please inform
your service provider
of the above error
code.
1 Clear any paper dust around the
document sensors.
2 Turn the scanner off then back on.
If the problem persists, write
down the displayed error code
and contact your FUJITSU
scanner dealer or an authorized
FUJITSU scanner service
provider.
L6:1B Sensor error
If the problem persists
after turning the power
back on, please inform
your service provider
of the above error
code.
1 Clear any paper dust around the
ultrasonic sensors.
2 Turn the scanner off then back on.
If the problem persists, write
down the displayed error code
and contact your FUJITSU
scanner dealer or an authorized
FUJITSU scanner service
provider.