User Manual

FCC Compliance Statement
Information to the User
NOTE: This equipment has been tested and found to comply
with the limits for a class B digital peripheral, pursuant to Part
15 of the FCC Rules and meets all requirements of the Canadian
Interference-Causing Equipment Regulations. These limits are
designed to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment on and off, the user is
encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected
• Consult the dealer or an experienced radio/T.V.
technician for help
Change or modifications not expressly approved by
Siemens PC Systeme GmbH & Co. KG
could void authority to operate the equipment.
If necessary, the user should contact the dealer or an
experienced radio/television technician for additional
suggestions. The user may find the following booklet,
prepared by the Federal Communications Commission,
helpful: "How to Identify and Resolve Radio-TV
Interference Problems." This booklet is available from the
U.S. Government Printing Office, Washington, D.C.,
20402, Stock No. 004-000-00345-4.