Operating Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparation for use and operation
- Unpacking and checking the delivery
- Preparing the PC for use
- Setting up the PC
- Connecting devices
- Connecting the PC to the line voltage
- Unlocking/locking the system unit
- Switching the PC on and off
- Indicators on the system unit
- Keyboard
- Working with floppy disks
- Settings in BIOS Setup
- Property and data protection
- Troubleshooting and tips
- System expansions
- Technical data
- Index
Assembling the system unit System expansions
A26361-K516-Z100-1-7619
31
Assembling the system unit
2
1
3
a
²
Place the side cover on the system unit in the direction of the arrow (1) so that the distance (a)
is approx. 10 mm.
²
Push the side cover in the direction of the arrow (2) until it engages.
²
Lock the side cover using the locking slide at the rear (3).
²
Return the system unit to its original position.
²
If you have disconnected cables, reconnect them at the rear.
Installing and removing a board
!
Observe the notes on installing and removing boards in the chapter "Important notes".
Old ISA boards which require a -5 V power supply are not supported.
The number, position and constellation of the board slots on the system board can be found in the
technical manual for the system board. Boards may be installed when the device is shipped.