Operating Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparation for use and operation
- Unpacking and checking the delivery
- Preparing the PC for use
- Setting up the PC
- Connecting devices
- Connecting the PC to the line voltage
- Unlocking/locking the system unit
- Switching the PC on and off
- Indicators on the system unit
- Keyboard
- Working with floppy disks
- Settings in BIOS Setup
- Property and data protection
- Troubleshooting and tips
- System expansions
- Technical data
- Index
System expansions Installing and removing drives
36
A26361-K516-Z100-1-7619
Removing an accessible drive
²
Open the system unit (see "Opening the system unit").
2
1
3
²
Pull the data and the power supply connectors from the desired drive (1).
²
Remove the screws (2) and take the drive out of the system unit (3).
A
B
²
Insert the shielding plate (B) on the right-
hand side on the installation bay and press
it in.
²
Press the plastic drive cover (A) into the
front panel until it snaps in place.
²
Close the system unit (see "Assembling
the system unit").
i
If necessary, you must adapt the entry for the drive in the Setup menu.