Operating Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparation for use and operation
- Unpacking and checking the delivery
- Preparing the PC for use
- Setting up the PC
- Connecting devices
- Connecting the PC to the line voltage
- Unlocking/locking the system unit
- Switching the PC on and off
- Indicators on the system unit
- Keyboard
- Working with floppy disks
- Settings in BIOS Setup
- Property and data protection
- Troubleshooting and tips
- System expansions
- Technical data
- Index
System expansions Installing and removing drives
40
A26361-K516-Z100-1-7619
Removing the second hard disk drive
1
1
1
2
²
Remove the screws (1).
²
Pull the hard disk drive out of the
carrier (2).
²
Make the required settings on the
remaining hard disk drive
(e.g. stand alone).
Installing the hard disk carrier
1
2
²
Plug the data and the power supply connectors into the hard disk drive or into the hard disk
drives.
²
Push the drive carrier into the system unit in the direction of the arrow (1).
²
Swivel the drive carrier in the direction of the arrow (2) until it clicks into position. Please ensure
that the guide rail is in the groove.
²
Close the system unit (see "Assembling the system unit").
i
If necessary, you must adapt the entry for the drive in the Setup menu.