Operating Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparation for use and operation
- Unpacking and checking the delivery
- Preparing the PC for use
- Setting up the PC
- Connecting devices
- Connecting the PC to the line voltage
- Unlocking/locking the system unit
- Switching the PC on and off
- Indicators on the system unit
- Keyboard
- Working with floppy disks
- Settings in BIOS Setup
- Property and data protection
- Troubleshooting and tips
- System expansions
- Technical data
- Index
Installing/removing a chipcard reader System expansions
A26361-K516-Z100-1-7619
41
Installing/removing a chipcard reader
²
Open the system unit (see "Opening the system unit").
Removing the hard disk carrier
1
2
²
Press on the clip (1).
²
Pull the carrier for the chipcard reader out of the system unit in the direction of the arrow (2).
Installing a chipcard reader
1
2
3
²
Remove the panel at the front of the
carrier.
²
Push the chipcard reader board into the
guide rail (1).
²
Fix the board with the screw (2).
²
Fix the cable on the chipcard reader (3)
and on the connector for the chipcard
reader on the system board (see the
Technical Manual of the system board).