Technical Manual

STEP 2: Selecting the function number and setting value
1. Press the TEMP./SELECT ( ) ( ) buttons to select the function
number. To switch between the left and right digits, press the
MODE button.
2. Press the FAN SPEED button to proceed the setting value. To re-
turn the function number selection, press the FAN SPEED button
again.
3. Press the TEMP./SELECT (
) ( ) buttons to select the setting
value. To switch between the left and right digits, press the MODE
button.
4. Press the TIMER button, and when the indoor unit beeps, press
the
/
(START/STOP) button to confirm the settings.
5. Press the RESET button to cancel the function setting mode.
6. After completing the function setting, be sure to disconnect the
power supply and then reconnect it.
Function number
Setting value
CAUTION
• After disconnecting the power supply, wait 30 seconds or more before reconnecting it. The func-
tion setting will not become active unless the power supply is disconnected and then reconnect-
ed.
• When using a custom code other than
, press RESET and then press and hold MODE again
for 5 seconds or more to set the custom code.
- 48 -
11-1. Function settings by using remote controller
11. Function settings
WALL MOUNTED ASUH30-36LPAS WALL MOUNTED ASUH30-36LPAS