Installation Manual

En-13
]1
12.5. Connecting cable to control board
connector
(1) Pass the cable from the hole in the back of indoor unit.
(2) Connect the cable to the control board connector.
(3) Hook the cable to the rib.
Option type Connector No
Wired remote controller
Simple remote contoroller
CN6
External input CN14
External output CN16
(4) Use cable clamper and screw to fasten the cable of wired
remote controller.
(5) Fix the binder clamp with the screw and bind the wire of
external kit with the binder.
]1
12.6. Front panel, control box cover and
display case installation
Install front panel, control box cover and display case by the
reverse procedures as stated in 12.4 Front panel, control box
cover and display case removal.
external connect wire
conduit holder
screw
binder clamp
original wire of
control box
external connect wire
binder clamp
screw
binder
screw
cable clamper
cable of wired
remote controller
original wire of control unit
conduit holder
cable
clamper
screw
connect the cable
rib
CN6
CN16
CN14
PCB
hole
9318739022_IM.indb Sec1:139318739022_IM.indb Sec1:13 2010-11-2 15:25:192010-11-2 15:25:19