Personal Computer User Manual

53
4
● Starting the computer after password setup
After ‘Set User Password’ is set, the personal computer displays a password entry window
when turned on again or the user attempts to run the BIOS setup utility.
Enter a password and press the Enter key.
Enter Password.
Enter Password.
After ‘Set Supervisor Password’ is set, the computer displays a password entry window
when the user attempts to run the BIOS setup utility. Enter a password and press the Enter
key.
If the user enters an incorrect password three times, the system stops, in which case the
Power switch must be pressed for at least four seconds to turn the system off. After waiting
at least ten seconds, turn the system on again and enter the correct password.
Changing passwords
To change a password, move the cursor to ‘Set Supervisor Password’ or ‘Set
User Password’ and enter the new password.
Deleting passwords
To delete a password, move the cursor to ‘Set Supervisor Password’ or ‘Set User
Password’ and press the Enter key.
Point