Printer User's Manual

Changing Hardware Options
8-26 User’s Manual
<FORMAT>
8 NONE 1
8 NONE 2
8 EVEN 1
8 ODD 1
7 EVEN 1
7 ODD 1
7 MARK 1
7 SPACE1
7 EVEN 2
7 ODD 2
Data bits Parity bit Stop bits
8 None 1
8 None 2
8Even1
8 Odd 1
7Even1
7 Odd 1
7Mark1
7 Space 1
7Even2
7 Odd 2
The data format also includes a start bit. The mark is
logical 1. The space is logical 0.
<BAUD-RT> 150
300
600
1200
2400
4800
9600
19200
The baud rate is given in bits per second (bps). Select the
same baud rate as for the processor or modem.
<PROTOCL>
X
ON/XOF
DTR
REV-CHL
Indicates the data transmission protocol.
DC1 and DC3 codes are used.
The Data Terminal Ready signal is used.
The Reverse Channel signal is used.
<DSR> IGNORE
DETECT
The printer ignores DSR.
The printer detects DSR.
<DUPLEX> FULL
HALF
Simultaneous data transmission occurs in opposite
directions.
Data transmission occurs in either direction, but not
simultaneously.
<CTS> IGNORE
DETECT
The printer ignores CTS.
The printer detects CTS.
Table 8–4 HARDWRE options (Continued)
HARDWRE item Options Description
DL6400/6600 Book Page 26 Thursday, September 21, 2000 7:52 PM