Printer User's Manual

Printing a List of Options
8-8 User’s Manual
5. Underlining beneath the first two letters of an option indicates the
current default setting. For example, 12
CPI indicates that 12
characters per inch is the default value. To change the default
settings, select and save a new setting.
6. While in setup mode, use LIST to print a list of currently selected
options. For details, see “Printing a List of Options” below.
7. To exit setup mode and permanently save changes, select either
SAVE & END or SELF-TST. For details, see “Exiting and Saving”
on page 8-35. To exit setup mode without saving changes, turn the
printer off. Previous default settings are activated when the printer
is turned on again.
LIST prints a list of all currently selected options. This list is useful for
checking settings when entering or exiting setup mode. To print
options, load continuous forms. Then do the following:
1. Enter setup mode
To center setup mode printer must be offline.
Press FONT and MENU simultaneously. Wait for the printer to
stop printing and check that the <<FUNCTION>> menu is
printed.
2. Select LIST.
Repeatedly press LOCK to position the yellow arrow on the print
head beneath LIST. Next, press FONT or MENU to select LIST.
The printer starts to print a list of current options. Figure 8-3 shows
the default values set at shipment.
Important:
To remove the printout, turn the platen knob until paper can be torn
off at the perforation. The TEAR OFF button cannot be used in setup
mode.
<<FUNCTION>>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT GAP-ADJ
Printing a List of
Options
(GAP-ADJ is printed only with APTC installed.)
DL6400/6600 Book Page 8 Thursday, September 21, 2000 7:52 PM