Operation Manual

System expansions
58 Fujitsu Technology Solutions
Removing the EMC cover
Before installing a hard drive or diskette drive in the 3½ inch slot on the front of the device, where
applicable you must again remove the EMC cover in the 3½ inch slot.
► Open the casing (see "
Opening the casing").
► If the EMC cover on your type of device is not secured with a screw, take the EMC cover out of
the 3½ inch slot.
If the EMC cover on your type of device is secured with a screw, proceed as follows:
► Remove the crosspiece
(see "Removing the cross-piece").
► Fold the drive cage upwards (see "
Folding up and down the drive cage").
► Remove the screw on the EMC cover (1).
► Fold the drive cage downwards (see "
Folding down the drive cage").