Operation Manual

System expansio ns
Installing and removing the accessible 5
1
/
4
inch drive
Fitting the drive cover for th
e5
1
/
4
inch drive
In order to use the locking function for the a ccessible 5
1
/
4
drive, the corresponding drive cover
must be fitted to the drive before the drive is installed in the casing. Proceed as follows:
The drive cover can be found either on the drive place holder or on the installed drive.
► Remove the casing cover (see Chapter "
Removing the casing cover", Page 37).
► Remove the acce ssible drive or the drive place holder (see "
Removing
an accessible dr ive", Page 44).
1
► Release the drive cover in the direction of the arrow (1) from the d rive/drive
placeholder that was removed.
1
► Attach the drive cover onto the drive/drive
place holder to be fitted ( 1).
Fujitsu 41