Operation Manual

Getting started
Connecting external devices to the USB ports
USBdevices,USBport,Externaldevices,Devices,
You can connect a wide range of external devices to the USB ports (e.g.
printer, scanner, modem or keyboard).
USB devices are hot-pluggable. This means you can connect and disconnect
USB cables while your device is switched on.
Additional information can be found in the documentation for the USB devices.
► Connect the data cable to the external device.
► Connect the data cable to one of the U SB ports on your device.
Device drivers
The external USB devices you connect to the USB ports usually require no driver of their
own, as the required software is alrea dy included in the operating s ystem. If the device
requires separate software, please note the information in the manufacturer’s manual.
To ensure the transmission capacity of USB 2.0, the cable from the external USB
device to the USB port of your device must not be longer than 3 m.
Switchingonforthefirst time: installing the software
Installing,Software,Installing,
Once the installation ha s been started the device m ust not be switched
off, unless the installation has been completed.
During installation, the device may only be rebooted when you are requested to do s o!
The installation will otherwise not be carried out correctly and the contents
of the hard disk must be completely restored.
If the device i
s integrated into a network, the user and server de tails as well as
the network p
rotocol are required during the software installation.
Contact you
r network administrator if you have any questions about these settings.
When you swi
tch on the device for the first time, the supplied software
is install
ed and configured. Plan a reasonable amount of time for this,
as this pro
cess must not be interrupted.
You may ne
ed the licence number for Windows during the installation. The licence
number is
located on a label on your device.
Fujitsu 17