Operation Manual

Getting started
► Depending on the device, connect the data cable to the parallel port or the serial port.
For an exact description of how to connect external devices to the corresponding
port, please refer to the documentation of the external device.
Port settings
ParallelportSerialport,
You can change the port setting
s (e.g. address, interrupt) in the BIOS Setup.
Device drivers
Devicedrive rsDevicedrive rs,
The devices connected to the parallel or serial port require drivers. Your operating
system already includes many drivers. If the required drive is missing, install it. Current
drivers are usually available on the Internet or will be supplied on a data carrier.
Connecting external devices to the U SB po rts
USBdevices,USBport,Externaldevices,Devices,
You can connect a wide range of external devices to the USB ports (e.g.
printer, sca nner, modem or keyboard).
USB devices are hot-pluggable. This means you can connect and disconne ct
USB cables while your device is switched on.
Additional information can be found in the documentation for the USB devices.
► Connect the data c able to the exte rnal device.
► Connect th e data cable to one of the USB ports on your d evice.
Device drivers
The external USB devices you connect to the USB ports usually require no
driver of their own, as the required software i s already included in the operating
system. However, if the external USB dev ice requires its own software, please
install it from the data carrier provided with the USB device.
To ensure the transmission capacity of USB 2.0, the cable from the external USB
device to the USB port of y our device must not be longer than 3 m.
Fujitsu Technology Solutions 21