User Manual
39
Before Using the Handset
F-02A_E1kou
❖
Tilting FOMA terminal
■
Rotating the screen display according to the orientation of FOMA terminal
While watching 1Seg, displaying Full Browser screen, playing 1Seg video, playing
a movie/i-motion or playing Music&Video Channel, tilting FOMA terminal 90
degrees counterclockwise switches the display to the horizontal display. Tilting the
terminal 90 degrees clockwise restores the vertical display.
・
While an image is displayed, the orientation of FOMA terminal is detected, and
display orientations and display size are automatically adjusted.
■
Flash graphics change
When setting Flash graphics compatible with motion sensor to stand-by display,
image changes by moving FOMA terminal.
■
Changing vertical/horizontal position or orientation of an image
automatically when shooting a still image
The orientation of still image to be saved changes automatically according to the
orientation of FOMA terminal.
→
P196
✔
INFORMATION
・
Depending on the location or strength of double-tapping, unintended operations may
be performed. Note that tapping too strongly may cause malfunction.
・
While walking or in a place with much vibration, double-tapping operations may not
work correctly.
・
It may operate as double-tapping when lifting FOMA terminal with your hand.
◆
Enabling Motion sensor <Motion sensor>
1
m
[Settings & NW services]
77e1
or
2
・
Even if setting to "OFF", the Flash graphics compatible with motion sensor
operate.
Using UIM (FOMA card)
UIM (FOMA card) is a card for storing user information such as phone numbers.
・
If UIM is installed incorrectly or if there is a problem with UIM, you cannot make/
receive a call or send/receive a mail.
・
For details on handling UIM, refer to the UIM manual.
◆
Installing/Removing
・
After turning the power OFF, fold FOMA terminal and hold it with your hand.
・
Take care not to touch or scratch the IC part.
・
Attaching/Removing back cover and battery pack
→
P42
■
Installing
a
Pull the tab and pull out the tray until it clicks.
b
Hold UIM with the IC side up, align the beveled corner with the tray and push into
the tray until it stops.
■
Removing
a
Perform
a
of installing operation.
b
Take out UIM.
仮
Tab
Tray
Corner cut
IC
UIM
L03.fm Page 39 Thursday, November 27, 2008 9:48 AM