User's Manual
Table Of Contents
F-08B_EN_FCC
21
Basic Operation
Before Using
Attaching UIM (FOMA card)/battery pack
After turning power OFF, close FOMA terminal and hold it in your
hand so that you can properly attach UIM/battery pack.
✜
Removing Back Cover
Slide the lever in the direction of
a
to unlock, pressing the back cover with a
thumb and slide approximately
●
mm in the direction of
b
to remove. Pinch
the tab of inner lid and hold it up in the direction of
c
to open until it stops.
✜
Installing UIM
Pull the tab with your nail and pull out the tray until it clicks (
a
). Hold
UIM with the IC side down, align the beveled corner with the tray (
b
)
and push into the tray until it stops (
c
).
Point
･
UIM (blue) is not available for this FOMA terminal. If you have the UIM
(blue), bring it to a docomo Shop.
✜
Installing battery pack
With the label side of the battery pack upward, align convex parts of the battery pack
with concave parts of FOMA terminal and slide the battery pack in the direction of
a
, press the battery pack in the direction of
b
to set it in and close the inner lid.
✜
Installing back cover
Place the 4 tabs of back cover to the notches, press back cover in the
direction of
a
to avoid forming any clearance between FOMA
terminal and back cover, then slide it in the direction of
b
to install it.
Point
･
The inner lid is designed to be closed firmly to maintain waterproofness.
Note that forcibly opening may hurt your nail or finger.
･
To avoid damage by forcible opening, hinge of the inner lid (joint part to
terminal body) is designed to be removed. If it is removed, align the pin metal
of the inner lid with groove of FOMA terminal and push it until it clicks.
Press here with your thumb
Back cover
Lever
Tray
Tab
IC
Corner cut
UIM
a
Battery pack
Convex parts
Concave parts
a
b
Back cover
a
b
Lever