User's Manual

F-09B_EN_ninshou
43
Before Using the Handset
■ Removing
a Pull the tab, pull out the tray until it clicks and remove UIM.
INFORMATION
･ Be careful that UIM or tray may be broken by forcible installing/removing of UIM, or by installing battery pack with
the tray inserted at a slant.
･ If you pull the tray too strongly and it is removed, press it straight along the guide rail inside the UIM slot. At this
time, perform this operation with UIM detached.
･ The FOMA terminal is unavailable for UIM (blue). If you have a UIM (blue), replace it at docomo Shop.
Security code
There are 2 kinds of security codes for UIM, the PIN code and PIN2 code. → p.138
Both of the default security codes are "0000", which you can change by yourself.
→ p.140
UIM operation restriction
FOMA terminal is provided with the UIM operation restriction for protecting user's data or file, or
protecting the data or file whose copyrights are held by the third party.
･ When data or files are downloaded from websites or data attached to mails are obtained to your
FOMA terminal with UIM equipped, the UIM operation restriction is automatically set to these data or
files.
･ With UIM replaced or no UIM installed, data or files with the UIM operation restriction set cannot be
displayed or played.
･ Data or files with the UIM operation restriction set cannot be transferred over infrared communication
transmission and copied/moved to microSD card.
･ The data that UIM operation restriction is enabled for are as follows.
- Recorded message of videophone call
- Screen memos
- Attached data of i-mode mail, images attached in mail message
- MessageR/F
- Images (including GIF animations, Flash graphics and images downloaded from Data Center), i-
motion or melodies
-i-
α ppli (including i- α ppli stand-by display)
- Chaku-uta
Tab
UIM card slot
L03.fm Page 43 Thursday, May 27, 2010 3:44 PM