User's Manual

F-09B_EN_ninshou
48
Before Using the Handset
･ When charging starts, the light turns on in red. In some environments, the light may not turn on
immediately when charging starts; but this is normal and not a malfunction. However, if the light does
not turn on after a while, disconnect FOMA terminal from the AC adapter or desktop holder then
connect it again to start charging. Contact the sales outlet such as docomo Shop if the light does not
turn on for a while after charging starts.
･ It is normal for FOMA terminal, battery pack, AC adapter or DC adapter to become warm while
charging. However, if you use a call or communication or operate other functions for a long time while
charging a battery, the temperature in FOMA terminal rises and the charging may not finish normally.
In that case, wait until the temperature falls down and try again.
･ If you use a camera while charging, the light turns off or blinks, but it is not a failure. When you stop
using a camera, the light turns on.
･ When installing the fully charged battery pack to FOMA terminal and connecting it to the AC adapter,
desktop holder or DC adapter, the light may turn on for a moment and turn off. This is normal and not
a malfunction.
･ While FOMA terminal is turned OFF, during a call, communication, in Silent mode or Public mode
(Drive mode) or with Charge alert set to "
知らせない (OFF)", the charge alert does not sound when
starting or completing the charging.
Charging method in combination with the desktop holder
You can charge a battery by using FOMA AC Adapter 01/02 (optional) connected with Desktop Holder
F30.
･ Place the desktop holder on the flat surface.
･ To install correctly, connect FOMA terminal in the folded state with the desktop holder. Be careful not
to put the strap, etc., between FOMA terminal.
a Insert the connector of the AC adapter to the desktop holder with the arrow on the AC adapter's
connector facing upward (
a ).
b Unfold the AC adapter's power plug and insert it into a 100V AC outlet ( b ).
c Install FOMA terminal with battery pack attached to the desktop holder firmly ( c ).
d The charging start sound is emitted, the light turns on and the battery icon on the sub-display blinks.
e When charging is over, a charge completion alert sounds, the light turns off and the battery icon on
the sub-display stops blinking.
f Remove FOMA terminal from the desktop holder.
Points of concern when charging the battery
L03.fm Page 48 Thursday, May 27, 2010 3:44 PM