AGU9RLF Operation Manual

En-12
MIN. (MINIMUM) HEAT OPERATION
• The room temperature can be maintained at 50 °F (10 °C) by pressing the MIN. HEAT
button (Fig.5
6
) so as to prevent the room temperature from falling too far.
To use MIN. HEAT OPERATION
Press the MIN. HEAT button (Fig. 5
6
)
The OPERATION Indicator lamp (green)(Fig.3
6
) will go out, and the ECONOMY
Indicator lamp (green)(Fig. 3
8
) will light.
• The direction of airÀ ow is set to horizontal.
To stop MIN. HEAT OPERATION
Press the START/STOP button (Fig. 5
1
)
Then the operation stops.
About the MIN. HEAT OPERATION
Starts MIN. HEAT operation that mainains the room temperature at 50 °F (10 °C) so as to prevent the room temperature to drop too
low.
When you press the button to start the MIN. HEAT operation, the indoor unit emits 2 short beeps and the ECONOMY indicator (green)
turns on.
Notes:
•
In MIN. HEAT operation mode, only vertical airÀ ow direction can be adjusted by using button.
•
HEAT mode will not be performed if the room temperature is warm enough.
•
In multi-type air conditioning system, if other indoor unit is in HEAT mode, the temperature of the room where MIN. HEAT operation is performed
will rise. When performing MIN. HEAT operation, all the indoor units should be run in MIN. HEAT operation mode. To return to normal operation,
press the START/STOP button. The ECONOMY indicator turns off.
ECONOMY OPERATION
Begin Air Conditioner operation before performing this procedure.
To Use the ECONOMY Operation
Press the ECONOMY button (Fig.5
H
).
The OPERATION Indicator lamp (green)(Fig.3
6
) and the ECONOMY Indicator lamp
(green)(Fig.3
8
) will light.
Economy operation begins.
To Stop the ECONOMY Operation
Press the ECONOMY button (Fig.5
H
) again.
The ECONOMY Indicator lamp (green)(Fig.3
8
) will go out.
Normal operation begins.
About ECONOMY Operation
Starts or stops ECONOMY operation that saves more electricity consumption than the other operations with a conservative adjust-
ment of the room temperature. When you press the button, the ECONOMY indicator on the indoor unit turns on.
• In COOL or DRY mode, the room temperature will be adjusted at a few degree higher than the de¿ ned temperature.
In HEAT mode, the room temperature will be adjusted at a few degree lower than the de¿ ned temperature.
• Especially in COOL or DRY mode, you can have improved dehumidi¿ cation without signi¿ cantly lowering the room temperature.
Notes:
•
In COOL, HEAT, or DRY mode, the maximum output of this operation is approximately 70 % of usual air conditioning operation.
•
This operation cannot be performed during temperature monitoring by AUTO mode.
•
In multi-type air conditioning system, ECONOMY operation is performed only on the indoor unit whose ECONOMY button on the corresponding re-
mote controller is pressed.
Indicator Lamp
TIMER OPERATION ECONOMY
: Lighting : OFF
Indicator Lamp
TIMER OPERATION ECONOMY
: Lighting : OFF
While MIN. HEAT OPERATION is in
progress, only the following operation
can be used.
• SET
9378532076_OM.indb 12 9/24/2013 4:35:27 PM