AGU9RLF Operation Manual

En-13
SWING OPERATION
POWERFUL OPERATION
MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the Remote Controller is lost or otherwise unavailable.
How To Use the Main Unit Controls
The product will operate at maximum power, which is convenient when you want to
quickly cool down or warm up the room.
When you press the button to start the POWERFUL operation, the indoor unit emits 3
short beeps.
POWERFUL operation is automatically turned off in the following situations:
• Adjusted room temperature reached to the de¿ ned temperature in temperature setting
in COOL, DRY, or HEAT mode.
• 20 minutes have passed after ¿ nishing the POWERFUL operation mode setting. It is
not turned off automatically during setting of the POWERFUL operation.
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 1
3
) more than 3 sec-
onds and less than 10 seconds on the main unit control panel.
To stop operation, press the MANUAL AUTO button (Fig. 1
3
) for 3 seconds.
●
When the air conditioner is operated with
the controls on the Main Unit, it will oper-
ate under the same mode as the AUTO
mode selected on the
Remote Control-
ler
(see page 6).
●
The fan speed selected will be “AUTO”
and the temperature setting will be stan-
dard. (76 °F (24 °C))
Begin air conditioner operation before performing this procedure.
To select SWING Operation
Press the SWING button (Fig. 5
9
).
The SWING Display (Fig. 5
J
) will light.
In this mode, the AirÀ ow Direction Louvers will swing automatically to direct the airÀ ow both up and down.
To stop SWING Operation
Press the SWING button (Fig. 5
9
) once again.
The SWING Display (Fig. 5
J
) will go out.
AirÀ ow direction will return to the setting before swing was begun.
About Swing Operation
Swings between
1
and
5
.
• The SWING operation may stop temporarily when the air conditioner’s fan is not operating, or when
operating at very low speeds.
Notes:
• The airÀ ow direction and the fan speed
are controlled automatically.
• This operation cannot be performed
simultaneously with ECONOMY
operation.
To return to normal operation, press the
button again. Then the indoor unit emits
2 short beeps.
9378532076_OM.indb 13 9/24/2013 4:35:27 PM