AGU9RLF Operation Manual

En-7
OPERATION
You can quickly start the operation with following 3 steps:
To Select Mode Operation
1
Press the START/STOP button (Fig.5
1
).
2
Press the MODE button (Fig.5
2
) to select the desired mode.
Switches operation mode in following order.
AUTO COOL DRY FAN HEAT
Notes in HEAT mode:
At the beginning of the operation, the indoor unit operates at very low fan speed for
about 3–5 minutes for preparation, and then switches to the selected fan speed.
Automatic defrosting operation overrides the heating operation when it is necessary.
To Set the Temperature
Press the SET TEMP. button (Fig. 5
3
).
button: Press to raise the temperature setting.
button: Press to lower the temperature setting.
Set desired temperature.
In COOL/DRY mode, the value needs to be set at lower temperature than current room temperature, and in HEAT mode, the value needs to be set
at higher temperature than current room temperature. Otherwise, corresponding operation mode does not start to work.
Temperature setting range
AUTO/COOL/DRY 64-88 °F (18–30 °C)
HEAT 60-88 °F (16–30 °C)
*:Temperature control is not available in FAN mode.
To Set the Fan Speed
Press the FAN button (Fig. 5
8
).
Each time the button is pressed, the fan speed changes in the following order:
Controls the fan speed.
(AUTO) (HIGH) (MED) (LOW) (QUIET)
When AUTO is selected, the fan speed is automatically adjusted according to the operation mode.
SUPER QUIET Operation
SUPER QUIET operation begins. The indoor unit’s airÀ ow will be reduced for quieter operation.
SUPER QUIET operation cannot be used during Dry mode. (The same is true when dry mode is selected during AUTO mode op-
eration.)
During Super Quiet operation, Heating and Cooling performance will be reduced somewhat. If the room does not warm up/ cool
down when using SUPER QUIET Operation, please adjust the air conditioner’s Fan Speed.
9378532076_OM.indb 7 9/24/2013 4:35:27 PM