Datasheet

Chapter 1 Components
1.2 Drive Enclosures
ETERNUS DX60 S2 Disk storage system User’s Guide -Operation-
24
Copyright 2011 FUJITSU LIMITED P3AM-5512-02ENZ0
● Part explanation
• AUTO POWER switch
The AUTO POWER switch of the drive enclosure is turned to "OFF" as the factory setting,
and should not be turned to "ON".
• MODE SELECT switch
Enables the device power to be turned on via power linkage.
The MODE SELECT switch is enabled for the factory default setting. Do not change to OFF.
• LEDs
The states of LEDs are listed below.
Table 1.8 Status and meanings of each LED (in front of drive enclosure)
■ Disk
Figure 1.21 3.5" disk
Figure 1.22
shows the slot number of each disk.
Figure 1.22 Disk slot numbers (drive enclosure)
LED name LED status Drive enclosure status
POWER
(green)
DC power is supplied to the drive enclosure.
READY
(green)
The ETERNUS DX Disk storage system is available for
use.
FAULT
(orange)
The drive enclosure is in error status.
(blinks orange)
A part of the drive enclosure requires preventive
maintenance.
IDENTIFY
(blinks blue)
As ordered via ETERNUS Web GUI, the installation
location of the drive enclosure is identified.
(off)
DISK READY/FAULT LED
Slot#0
Slot#4
Slot#8
Slot#1
Slot#5
Slot#9
Slot#2
Slot#6
Slot#10
Slot#3
Slot#7
Slot#11