Operation Manual

Getting started
Getting started
Gettingstarted
Please observe the safety information in the " Important notes", Page 10 chapter.
Setting up the device
In order to ensure that the casing is sufficiently ventilated and to preven t overheating,
the device must only be operated with the base foot attached.
If the device is to be built-in, adequate ventilation must be assured.
Fit the base feet for h
orizontal or vertical operation (see "
Vertical o perating
position", Page 16 and
"
Horizon tal operating position", Page 19).
Vertical operati
ng position
VerticaloperatingpositionOperatingposition, verticalBasefeetSidecover
If you wish to operate the device in the vertical operating position, use
the two feet supplied for vertical ope ration.
Only mount the feet on t he device side shown in the diagrams.
If conne cting many cables to the device, e nsure that the device is in a stable
position, in order to prevent it from toppling over.
Proceed as fo llows to prepare the d evi ce for the vertical operating position:
► Disconnect the cables if required.
► Lay the device on i ts top (narrow side) as shown, on a stable, flat an d clean surface.
16 Fujitsu