Operation Manual

Getting started
Connecting external devices to the serial i nterface
SerialinterfaceSerialinterface,Externaldevices,Devi ces,
External devices can be connected to the serial interface (e.g. a printer or modem).
► Connect the data cable to the external device.
► Connect the da ta cable to the corresponding serial interface.

For an exact description of how to connect extern al devices to the corresponding
port, please see the external device documentation.
Port settings
Serialinterface,
You can change the port s ettings (e.g. address, interrupt) in the B IO S Setup.
Device drivers
Devicedrive rs,
The devices connected to the serial interface r equire drivers. Your operating syste m
already includes m an y drivers. If the required drive is missing, install it. The latest
drivers are usually available on the Internet or will be supplied on a data carrier.
Connecting external devices to the USB ports
USBdevices,USBport,Externaldevices,Devices,
You can connect a wide range of external devices to the USB ports (e.g.
printer, scanner, modem or keyboard).
USB devices are hot-pluggable. This means you can connect and disconnect
USB cables while your device is switched on.
Additional information can be found in the docum entation for the USB devices.
► Connect the data cable to the external device.
► Connect th e d
ata cable to one of the USB ports o n your device.
Device drivers
The extern
al USB devices you connect to the USB ports usually require no driver of their
own, as the
required software is already included in the operating system. If the device
requires
separate s oftwa re, please note the information in the ma nufacturer’s manual.
To ensure
the transmission capacity of USB 2.0, the cable from the external USB device
to the US
B port of your device must not be longer than 3 m / 118.11 inches.
Fujitsu 23