Operation Manual
System expansio ns
Removing the SmartCard reader
SmartCardread er
► Open the casing (see "Opening the casing", Page 32).
► If a PCIe board is installed, you must rem ove the cross piece and PCIe
board (see "
Removing the board", Page 58).
1
3
3
4
2
► Disconnect the cable from the SmartCard reader (1) and from the mainboard (2).
► Undo the screws ( 3).
► Lift the SmartCard reader from the carrier (4).
► When required, reinstall the cross piece and the PCIe board (see "
Installing the board", Page 56).
► Clo se the casing (see "
Closing the ca sing", Page 60).
Ensure tha t cables are not trapped between the casing and the com ponents.
Fujitsu 37