Operation Manual

Important notes

Safety notes for the system

This device com plies with the relevant safety regulations fo r data processing equipment,

including electronic o fﬁce machines for u se in an ofﬁce environment. If you have

any questions about whether the device can b e used in the intended environment,

please conta ct your sales ofﬁce or our Service Desk.

• The display surface of the device is s ensitive to pressure and scratches. You should therefore

be careful with the display surface in order to avoid lasting damage (scratches).

• If the device is brought into the installation site from a cold environment, condensation

can form. Before operating the device, wait until it is absolutely dry and has re ached

approximately the same temperature as the installation site.

• When installing and op erating the device, please observe the notes on ambient

conditions in "

Technical data", Page 58 and the instructions in "Settin g up

an ergonomic video workstation", Page 20.

• To ensure s ufﬁcient ventilation, the air inlet and outlet openings of the device must be kept clear.

• The device automatically sets itself to the correct voltage within th e range from 100 V to 240 V.

Make sure that the local mains voltage is neither higher nor lower than this range.

• Ensure that the power socket on the device and the m ains outlet are freely acce ssible.

• The ON/OFF switch does not disconnect the monitor from the mains voltage. To disconnect

fully from the mains supply, disconnect the power plug from the socket.

• The device is equipped with a power cable that complies with safety standards.

• Use the supplied power cable only.

• Lay the cab les in s uch a way that they do not create a hazard (danger of tripping)

and cannot be damaged. When connecting the device, observe the relevant n otes

in chapter "

Connecting external devices", Page 25.

• No data transfer cables should be connected or disconne cted during a thunderstorm.

• Make sure that no objects (e.g. jewe llery chains, paper clips, etc.) or liquids get

inside the device (danger of electric shock, short circuit).

• The device is not waterproof! Never immerse the device in water and protect

it from spray water (rain, sea water).

• In an emergency (e.g. damaged casing, operation controls or cables, penetration

of liquids or foreign matter), switch off the device, disconnect the power plug

and contact your sale s outlet or our Service Desk.

• Repairs to the device must only be performed by qua li ﬁe d technicians. Unauthorised opening

and incorrect repair may greatly end anger the user (electric shock, ﬁre risk).

• Only use the screen resolution settings and refresh rates speciﬁed in Chapter

Technical data", Page 58. Othe rwise you may damage the device. If you are in

any doubt, con tact your sales outlet or our Help Desk.

• Use a screen saver with m oving images and activate the power management for

your monitor t o prevent still images from "burning in".

• We recommend that you place your device on a durable, non-slip surface. In view

of the many different ﬁnishes and varnishes used on furniture, it is possible that the

feet of the device m ay mark the s urface they stand on.

Fujitsu 13