Operation Manual

Important notes
Power cable
Use the supplied power cable only.
Use the following guidelines if it is nece ssary to replace the original cable set.
• The female/male receptacles of the cord set must meet IEC60320/CEE-22 requirements.
• The cable has to be HAR-certified or VDE-certified. The mark HAR or
VDE will appear on th e outer sheath.
• For devices which are mounted on a de sk or table, type SVT or SJT cable sets may be
used. For devices which sit on the floor, only SJT type cable sets may be used.
• The cable set must be selected according to the rated current for your device.
• If necessary, replace the original power cable with a regular grounded 3-core mains lead.
Transporting the device
Device,Transporta tionRetransportation
Transport all parts separately in their original packaging or in a packaging which
protects them from knocks and jolts, to the new site.
Do not unpack them until all transportation manoeuvres are completed.
If the device is brought from a cold environment into the room where it will be
used, condensation m ay occur. To avoid damaging the device, wait until it has
reached room temperature and is absolutely dry before initial startup.
Cleaning the device
Device,Transporta tionRetransportationSyst emunit, seeDevice
Turn off all power and equipment switches and disconnect the pow er
plug from the mains outlet.
Do not clean any interior pa rts yourself, leave this job to a service technician.
Do not use any cleaning agents that contain abrasives or may corrod e
plastic (alcohol, thinner or acetone).
Never clean the device with water! Water enterin g into th e device could
present a serious risk to users (e.g. electric shock).
Ensure that no liquid enters the system.
The surface of the m onitor is sensitive to pressure and scratches. Clean
it only using a soft, slightly moistened cloth.
The surface can be cleaned with a dry cloth. If particularly dirty, use a cloth that has been
moistened in mild domestic detergent and then carefully wrung out.
Use disinfectant wipes to clean the keyboard and the mouse.
Energy saving, disposal and recycling
DisposalEnergysavingRecyclingDrivers&UtilitiesDVDUserDocumentationDVD
You ca
n find information on these s ubjects in chapter "
Activating power-saving
mode
", Page 31, on the "Drivers & U tilities", the recovery DVD or on our website
("
ht
tp://ww w.fujitsu.com /fts/about/fts/environment-care /").
14 Fujitsu