Technical data
Removing and installing components
during servicing
Attaching the cover
2
2
1
► Place the cover in the correct mounting position (1).
If you remove more than one component at the same time, keep the screws for the
individual components s epa rately from each other and make sure that you use the
correct screws. I f you install the wrong screws, componen ts may be damaged.
► Tighten the screws (2).
► In ser t the battery (see Chapter "
Installing the battery", Page 31).
Finishing component removal
After you have remo ved or changed the system components as you required, please
prepare your device for operation again as follows:
► In stall the bat tery again (see "
Installing the ba ttery", Page 31).
► Turn the not ebook the right way up again a nd place it on a flat surface.
► R eco nnect the cables that you disconnected before.
66 Fujitsu