User's Manual

15
□ LED list
LED Status of main unit Status of LED
Status LED
(Green and Red)
Calling
Green flashing
Emergency announcement
Dangerous Heat Disorder
announcement
Talking Green lights
Equipment abnormality occurs in Red flashing
During a firmware update Green fast flashing
Power LED
(Green)
Power ON Lighting
Power OFF Turning lights off
Camera LED
(Green)
Camera use Lighting⇒20 seconds after off
Camera unused Turning lights off
WLAN Connect LED
(Green)
WLAN setting in Green flashing
WLAN setup complete Green lights⇒3 seconds after off
Network communication possible Green lights
BLE Pairing LED
(Green and Red)
Pairing in
Green flashing
*Up to 30 seconds
Pairing establishment Green lights⇒3 seconds after off
Pairing failed Red flashing⇒3 seconds after off
* All LED is turned off when the power supply of the main unit is off.
* When the WLAN is cut in the out of the sphere etc. after the WLAN is connected, the WLAN Connect LED is turned off.
* The BLE Pairing LED does not light while connected it after the BLE pairing succeeds.
* The Status LED might seem flashing to orange if equipment abnormality occurred while the Status LED is lighting or flashing
to green.
* When the Status LED has flashed in red or orange, an equipment abnormality occurs. Please put the power supply of the main
unit again.
□ Connection of external devices
Capable of connecting external devices
UBIQUITOUSWARE Vital Sensing Unit
・The maximum number of connections to a single Remote Monitoring Station : 4
・Connection method : Select from the connection by the pairing and by the whitelist