Operation Manual

Hinweise des Herstellers
Regulatory notices
If there is no FCC logo and also no FCC ID on the device then this device is
not approved b y the Federal Co mmunications Commission (FCC) of the USA.
Although it is not explicitly forbidden to travel the US trading area carrying this
device, but to avoid trouble at customs clearance Fujitsu Technology Solutions
GmbH recommends not to bring this device into the U S trading area.
Regulatory information f
or notebooks without radio d evice
Regulatoryinformation
NOTICE:
Changes or modifications not expressly approved by Fujitsu Technolog y Solutions
could void this user’s auth ority to operate the equipment.
Notice to Users of Radios and Television
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. T his equipment generates, uses, an d c an radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment d oes cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the sep
aration between the equipment and receiver.
• Connect the equipment into an outlet that is on a different circuit than the receiver.
• Consult the dea
ler o r an experienced radio/TV technician for help.
Notice to Users of the US Telephone Network
You r notebook may be supplied with an internal modem which complies with Part 6 8 of the
FCC rules. On this notebook is a label that contains the FCC Registration Number and the
Ringer Eq uivalence Number (REN) for this equi pment among other information. If requested,
the user must provide their telephone company with the following information:
1. The telephone number to which the notebook is connected.
2. The Ringer
Equivalence Number (REN) for this equipment.
3. The equipment requires a standard modular jack type USOC RJ-11C
which is FCC Part 68 compliant.
4. The FCC Re
gistration Number.
This equipment is designed to be connected to the telephone network or premises wiring using
a s tandard modular jack type USOC RJ-11C which is FCC Part 68 compliant and a line cord
between the modem and the telephone network with a minimum of 26AWG.
The REN is used to determine the number of devices that you m ay connect to your telephone
line and still have all of those devices ring when your number is called. Too many devices
on one line m ay result in failure to ring in response to an incoming call. In most, but not all,
areas the sum of the RENs of all of the devices should not exceed five (5). To be certain
of th e number of devices you may connect to your line, as determined by the RENs, contact
your local telephone company. If this equipment causes harm to th e telephone network, your
telephone company may discontinue your service temporarily. If po ssible, they will notify you
in advance. If advance notice is not practical they will notify you as soon as possible. You
will also be advised of your right to file a complaint with the FCC.
Fujitsu 75