Operation Manual

Ports and operating elements
Removing and installing the bat
tery
NotesBattery
Only use batteries approved by Fujitsu Siemens C ompute rs for your notebook.
Never use force when inserting or removing a battery.
Make sure that no foreign bo d ies get into the battery connections.
Removing the battery
► Switch the notebook off and pull the power plug out of the mains socket.
Battery
► Close the LCD screen so that it locks i
nto place.
► Disconnect all cables connected to the notebook.
► Turn your notebook over and place it on
a stable, flat and clean surface. If necessary, lay
an anti-slip cloth on t his surface to p
revent the notebook from being scratched.
2
1
3
► Slide the battery release in the direction of the arrow (1) and hold it in place.

The battery release is unlocked.
► Slide the hard disk carrier in the direction of the arrow (2) a s far as it will go.

Aredfield appears on the ba ttery release.
► Slide the battery release in the direction of the arro w (1) again and hold it in place.
► Tilt the battery on the red field of the battery release to one side and lift
it out of the battery compartment (3).
A26391-K225-Z120-1-7619 , edition 1 15