Operation Manual

Removing and installing components
during servicing
Preparing to remove components
If you are going to remove or ch ange system c omponents, prepare for the removal as follows:
Please observe the safety information in chapter "Import ant notes", Page 13.
Remove the power plug from the mains o utlet !
► Switch the device off.
The de vice must not be in energy-saving mod e !
► Close the LC D screen.
► Remove all the cables
from t he device.
► Turn the device over and place it on a stable, flat and clean surface. If necessary, lay an
anti-slip cloth on this surface to prevent the device from being scratched.
► Remove the battery
(see "
Removing a b attery", Page 36).
Installing and removing memory expansion
MemorymoduleMainmemoryRemovingmemor
y
Systemexpansi
on
Systemexpansi
on
If you are asked by the Hotline/Service Desk to remove and install the memory
expansion y ourself, proceed as follows:
Please observe the safety information in chapter "Import ant notes", Page 13.
When installing/removing memory modules, the battery must be removed from
the notebook and the notebook must not be connected to the power supply,
see "
Preparing to remove components", Page 74.
Only use memory expansion modules that have been a pproved f or y our
notebook (see "
Tec hnical data", Page 89).
Never use force when installing or removing a memory extension.
Make sure that foreign objects do not fall into the memory extension compartment.
You must open the service compartm ent to remove or install a memory module. On some devices,
opening the compartment may expose other components. These components should be removed
and replaced only by authorised specialists. T heref ore, be sure to observe the following:
Individual components c an become very hot during operation. Therefore, we
recommend th at you wait one h our after switching off the notebook before removing
or installing memory modules. Otherwise, there is a risk of suffering burns!
As some components are exposed that are sensitive to static electricity, please take
note of chapter "
Notes on installing and rem oving boards and components", Page 73.
74 Fujitsu